Whiteline F&R Sway bar Link Assembly, Extra Heavy Duty Alloy Forester/Impreza/Legacy

The kit utilises a high tensile extruded alloy link fitted with ultra low compliance synthetic elastomer bushings. Critical hardware is replaced with high tensile components to match the higher loads. The result is much more precise & direct roll control with up to 25% more effective bar rate available at lower wheel deflection points. This does NOT mean an outright increase in your bar rate but rather a quickening of its effect allowing more bar rate earlier. Link shape & bush mounts are designed to allow maximum sway bar articulation to ensure full suspension travel while acting more directly under vertical load. Standard length maintains correct sway bar operation.

Install Guide
Vehicle set-boxed KLC26 & KLC30

Link Type: Bushing

Bolt Diameter: 8/10mm

Overall Length: 65mm

Configuration: Horizontal Bushing/Horizontal Bushing

Alloy Link Inc Hardware